Reid Big Block Mopar Bellhousing BH040
Big Block Mopar bellhousing for the Powerglide and TH400, fits 361-383-400-413-426-440 B and RB series engines including the 426 GEN II Hemi. Cast from high-strength aluminum and heat treated for additional toughness, the bellhousing passes the stringent SFI 30.1 certification* and is approved with no external shields required. The bell weighs only 13.0 pounds, features an open bottom for easy converter access, a reduced diameter for better floorboard clearance, and a contoured mounting flange to properly match the rear of the engine block. These bellhousings allow for direct fit to the engines with no spacers or adapters needed. Designed for use with a 130 tooth flexplate, stock style starters are used in the factory location. Since most cars use a 1/4” thick rear motor plate, the starter snout boss has been moved 1/4” forward on this bellhousing. It will also accept the larger 168 tooth Chevy-style flexplate. Length is the same as the Chevy bellhousing.
- For use with Powerglide and TH400 Transmissions
- Heat Treated 6061-T6 Aluminum
- SFI 30-1 Certification, No Additional Shield or Blankets Required
- Works with Stock Type Starters and 168 Tooth Flexplate
NOTE: THIS BELLHOUSING DOES NOT FIT THE REID RACING S80 4L80E REPLACEMENT CASE.