Reid Powerglide Tailhousing with TH400 Roller Bearing PGH2R
$359.00 Each
The Reid Racing, Inc. tailshaft housings are designed to fit both the REID Superglide and the stock GM Powerglide transmissions. 5 times stronger than stock, yet weighs only 4-1/2 pounds.
- Bolt in replacement – length and crossmember mounting flange is exactly the same as stock
- Double lip seal
- Relocated vent puts an end to the problem of trans fluid spraying out of breather
- Completely pre-assembled
- Includes a hardware kit with everything you need to bolt it on
Special Note: No speedometer cable provision is supplied.
This model is used when the Powerglide has a Turbo 400 output shaft. The driveshaft yoke is supported by a roller bearing instead of a bushing. A special hardened oversize Turbo 400 yoke is required.